Shaver display
The shaver display (8) shows the charge status of the battery. During charging or when using the shaver, the respective green battery segment will blink. When fully charged, all green segments will light up for approximately one hour, provided the shaver sits in the C&R station.
The red low charge segment flashes when the battery capacity has dropped below
20 %, provided the shaver is switched on. The remaining capacity will then be sufficient for 2 to 3 shaves.
Tips for the perfect shave
For best results, Braun recommends you follow 3 simple steps:
1.Always shave before washing your face.
2.At all times, hold the shaver at right angles (90°) to your skin.
3.Stretch your skin and shave against the direction of your beard growth.
Shaving with the cord
If the shaver has run out of power
(discharged), you may also shave with the shaver connected to an electrical outlet via the special cord set.
B Shaving
Press the on/off switch (7) to operate the shaver.
Comfort setting switch «sensitive» (5) Setting the shaver head according to your comfort needs.
The «sensitive» switch (5) provides three options for comfort setting:
1« + » :
The shaver head is in full swing, freely follows the contours of your skin to provide more comfort.
2middle position:
The shaver head is
3« – » :
The shaver head is fixed for full control and precise handling in hard to reach areas.
Long hair trimmer (4)
To trim sideburns, moustache or beard, slide the long hair trimmer upwards.
Cleaning
For best shaving results, we recommend cleaning the shaver in the station after each shave (see «Automatic cleaning»).
All charging and cleaning needs are then automatically taken care of.
Cleaning indicator
Clean your shaver in the Clean&Renew
station at the latest when the yellow cleaning light (9) shines constantly after shaving.
If this is not done, the cleaning light will go off after some time and the counter will be reset.
C Automatic cleaning
The Clean&Renew has been developed for cleaning, charging and storing your shaver. After each shave, return the shaver to the Clean&Renew station and proceed as follows:
•Insert the shaver head down into the cleaning station.
•Push down the start button (4). The cleaning process will start (approx.
5 minutes cleaning, 4 hours drying).
•Do not interrupt the cleaning process, as it leaves the shaver wet and not fit for use.
31
