PACarge header& cleaning.....
Error Message
When the deep fryer needs to be reset a RESET message will flash on the display. To reset, allow the deep fryer to cool completely, and then press the two red reset buttons located above the cord storage area at the back of the control panel.
If the Temperature Control detects oil temperature to be less than
If the Temperature Control detects the oil temperature to exceed 210°C the display will show the message ER2. Reset the unit as per above.
Auto Cutout safety feature
Always add the required amount of oil BEFORE switching the power on at the power outlet. An Auto
CLEANING
•Before cleaning, always ensure the deep fryer is turned off and disconnected from the power outlet.
•Ensure the deep fryer and oil are completely cool. Oil will retain its temperature for a long time after use. Do not attempt to move or carry the deep fryer, element or control panel while they are hot.
•Wash the frying basket in hot, soapy water. Rinse and dry thoroughly.
•Remove the control panel/element of the deep fryer by lifting upwards. Place the element onto kitchen paper to absorb excess oil. Wipe element with a soft, damp cloth and dry thoroughly.
•Grasp each side of the removable frying bowl and lift upwards.
•Empty the cooled oil from the frying bowl. Oil can be reused several times, depending on the type of food cooked. Filter the oil through a fine sieve.
NOTE
Oil should be filtered after each use and stored in a clean, airtight container in a cool area. Good quality oil can be used several times. Do not store the oil in the deep fryer. Discard used oil in a sealed container with household waste. Do not pour down a sink or drain.
•Wash the lid, removable inner frying bowl, stainless steel outer body and wire frying basket in hot soapy water, rinse and dry thoroughly The removable inner bowl allows for easy cleaning. Wipe the bowl with paper towel, then a damp cloth and a little mild detergent. Finish off with a clean damp cloth followed by a clean dry cloth.
22
