BREVILLE RECOMMENDS SAFETY FIRST

SPECIAL SAFETY INSTRUCTIONS

Congratulations on your purchase of your new Breville Espresso/Cappuccino Maker. We at Breville are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer, foremost in mind.

In addition, we ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions:

IMPORTANT SAFEGUARDS

SPECIAL SAFETY

INSTRUCTIONS

The cup-warming plate will always be

heating when the appliance is switched on

at the power outlet. Please switch off and

unplug when not in use.

Only use cold water in the water tank. Do

not use any other liquid.

Never use the appliance without water in it.

Before removing the Water Tank Cap

ensure the Pressure Indicator Button has

dropped down and is flush with the top of

the cap.

To avoid possible burns from hot steam

and water, never remove the water tank

cap or filter holder while there is steam

pressure in the water tank. Remove all

steam pressure first.

Do not immerse cord, plug or Espresso/Cappuccino Maker body in water or any other liquid.

Always use the appliance on a dry, level surface.

Before use fully unwind the power cord.

Do not let the cord hang over the edge of a table or counter, touch hot surfaces, or become knotted.

Do not place this appliance on or near a hot gas or electric burner, or where it could touch a heated oven.

Always turn the Selector Control to ‘STANDBY’, switch the power off at the power outlet and then remove the plug when the appliance is not being used and before cleaning.

The appliance is not intended for use by young children or infirm persons without supervision.

Do not leave the appliance unattended when in use. Young children should be supervised to ensure that they do not play with the appliance.

This appliance is for household use only.

Do not use this appliance for anything other than its intended use. Do not use outdoors.

Do not touch hot surfaces. Use handles.

Regularly inspect the supply cord, plug and actual appliance for any damage. If found damaged in anyway, immediately cease use and return the entire appliance to the nearest authorised Breville Service Centre for examination, replacement or repair.

Any maintenance other than cleaning should be performed at an authorised Breville Service Centre.

The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance. See your electrician for professional advice.

Ensure the water tank cap and filter

holder are firmly secured when using

the appliance.

Always ensure the water tank cap is clean

around the seal and the centre valve area

(never use if the seal is damaged or faulty).

As part of regular maintenance, it is

recommended that this appliance be

taken to the nearest authorised Breville

Service Centre for checking of the

‘Pressure Indicator Button’ once every

two years.

Refer to Page 11 for instructions on how

to release the steam pressure.

 

TO AVOID POSSIBLE BURNS FROM HOT STEAM AND WATER, NEVER OPEN

 

 

THE WATER TANK CAP WHILE THERE IS PRESSURE IN THE WATER TANK.

 

4

REMOVE ALL PRESSURE FIRST.

5

Page 3
Image 3
Breville ESP4 manual Special Safety Instructions