Breville ESP4 manual Preparing the Coffee, Brewing the Coffee

OPERATING YOUR BREVILLE ESPRESSO/CAPPUCCINO MAKER

OPERATING YOUR BREVILLE ESPRESSO/CAPPUCCINO MAKER

PREPARING THE COFFEE

•Remove the filter holder by rotating 45 degrees to the left (Fig 2 ).

fig 2

•Clean any excess ground coffee from the rim of the filter holder to ensure a proper fit under the brew head.

•Place the filter retainer clip in the release position by pulling the clip back towards your hand.

•Place the filter holder underneath the brew head so that the handle is positioned to the left of centre. Lift the filter holder until it contacts the brew head and rotate to the right.

BREWING THE COFFEE

The twin nozzle filter holder allows you to make either one or two espresso coffees at a time.

• Make sure the drip tray is in place. Place

empty coffee cups on the drip tray under

the filter holder.

• Make sure the Brew/Steam Selector

Control is in the ‘STANDBY’ position.

• Plug the power cord into a 230/240v

power outlet and switch on.

• The red power ‘On’ light will illuminate

when the appliance has been switched on

Water Tank Cap will rise when sufficient steam pressure is achieved.

• When sufficient coffee has flowed into the

cups, turn the Selector Control back to

the ‘STANDBY’ position. This will stop the

flow of coffee.

• If you are not continuing to using the

steam function, switch off at the power

outlet, unplug the power cord, remove all

pressure and allow the appliance to cool.

• Do not remove the water tank cap or filter

holder until the steam pressure in the

appliance has been released. The

Pressure Indicator Button should drop

•Place the 2 or 4 cup filter into the filter holder and use the measuring spoon to fill the filter with ground espresso coffee to the required cup level marking inside the filter (use the smaller filter for 1 or 2 cups and the larger filter for 2 or 4 cups). Do not fill above the 2 or 4 cup mark.

•Distribute the ground coffee evenly and press it lightly with the measuring spoon (Fig 3 and 4). Too much coffee can block the flow of water.

	correct
fig 3	(level)

Incorrect fig 4 (Heaped)

at the power outlet and the cup warming

plate will start heating.

• Rotate the Selector Control to the ‘BREW’

position . The orange heating light will

illuminate to let you know the water is

heating. Coffee will begin to flow into the

cups in approximately five minutes.

• The Pressure Indicator Button on the

down and be flush with the top of the

water tank cap.

The steam pressure in the machine must be released each time BEFORE re-filling with fresh cold water.

	THE METAL PARTS OF THE FILTER HOLDER MIGHT STILL BE VERY HOT.
	COOL DOWN THESE PARTS BY RUNNING UNDER COLD WATER.
	TO AVOID POSSIBLE BURNS FROM HOT STEAM AND WATER, NEVER OPEN
	THE WATER TANK CAP WHILE THERE IS PRESSURE IN THE WATER TANK.
	REMOVE ALL PRESSURE FIRST.
	NEVER LET COFFEE OR WATER LEVEL IN A CUP REACH THE POURING
8	NOZZLE OF THE FILTER HOLDER.	9