7000W Generator

ASSEMBLY

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at

1-800-743-4115.If calling for assistance, please have the model, revision, and serial number from the data tag available.

Remove Generator From Carton

1.Set carton on a rigid flat surface with “This Side Up” arrows pointing upward.

2.Carefully open top flaps of shipping carton.

3.Cut down corners of carton from top to bottom and lay that side of carton down flat.

4.Remove all packing material, carton fillers, etc.

5.Remove generator from shipping carton.

Attach Handle

You will need two 1/2” or 13mm wrenches to attach handle.

1.Attach handle to right side of generator frame (viewing unit from front), as shown in Figure 1, with a 60 mm capscrew, flat washers, nylon washers, and lock nut.

Figure 1 — Attach Handle

Handle Pin

Lock Nut

Flat Washers

 

60mm Capscrew

 

 

 

Nut

Washer

Handle Bracket

Nylon Washer

Nylon Washer

Handle Bracket

Washer

60mm Capscrew

Handle Pin

NOTE: DO NOT overtighten. Handle must be able to move up and down freely.

2.Raise handle and insert handle pin to move generator.

6