2800 PSI Pressure Washer
SPECIFICATIONS
Rated Pressure . . . . . 2800 pounds square inch (psi)
Flow Rate . . . . . . . . . . 2.5 gallons per minute (gpm)
Detergent . . . . . . . . . . Use detergent approved for pressure washers
Water Supply Temp . Not to Exceed 100°F
Automatic Cool | . . . . Will cycle when water |
Down System | reaches |
Shipping Weight | . . . . 90 lbs. |
GENERAL MAINTENANCE RECOMMENDATIONS
The pressure washer warranty does not cover items that have been subjected to operator abuse or negligence.To receive full value from the warranty, the operator must maintain the pressure washer as instructed in this manual.
•Some adjustments will need to be made periodically to properly maintain your pressure washer. Check the spray gun and spray tips for wear.
•All maintenance in this manual and the engine owner’s manual should be made at least once each season.
•If equipped with inflatable tires, keep the air pressure at the value marked on the tire or within 15 and 40 psi.
Before Each Use
•Check engine oil level.
•Check water inlet screen for damage.
•Check
•Check high pressure hose for leaks.
•Check detergent siphoning tube and filter for damage.
•Check spray gun and nozzle extension for leaks.
•Rinse out garden hose to flush out debris before connecting to pressure washer.
PRESSURE WASHER
MAINTENANCE
Check and Clean Inlet Screen
Examine the screen on the pumps water inlet. Clean it if the screen is clogged or replace it if screen is damaged.
Check High Pressure Hose
The high pressure hose can develop leaks from wear, kinking, or abuse. Inspect the hose each time before using it. Check for cuts, leaks, abrasions or bulging of cover, damage or movement of couplings. If any of these conditions exist, replace the hose immediately.
WARNING
The high pressure stream of water that this equipment produces can pierce skin and its underlying tissues, leading to serious injury and possible amputation.
•NEVER repair high pressure hose. Replace it.
•Replacement hose rating MUST exceed maximum pressure rating of unit.
Check Gun and Nozzle Extension
Examine the hose connection to the spray gun and make sure it is secure.Test the trigger by pressing it and making sure it “springs back” into place when you release it. Put the safety latch in the ON position and test the trigger.You should not be able to press the trigger.
Check In-Line Filter
Refer to Figure 15 and service the
Figure 15 — Clean In-Line Filter
Filter Screen
Nozzle Extension
O-ring
1.Detach spray gun and nozzle extension from high pressure hose. Detach nozzle extension from spray gun and remove
12
