2800 PSI Pressure Washer
ASSEMBLY
IMPORTANT: Read entire owner’s manual before you attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From Carton
•Remove the parts bag packed with pressure washer.
•Slice two corners at the end of carton from top to bottom so the panel can be folded down flat, then remove all packing material.
•Roll pressure washer out of carton.
Carton Contents
Items in the carton include:
•Main Unit
•Safety Goggles
•Handle
•Hose Reel Components
•Chemical Reservoir Assembly
•High Pressure Hose
•Spray Gun
•Nozzle Extension with Quick Connect Fitting and Tip Holder
•Oil Bottle
•Parts Bag (which includes the following):
•Owner’s Manual
•Engine Manual
•Owner’s Registration Card
•Bag containing 4
•Maintenance Kit
•Handle Fastening Hardware Kit (which includes):
•Carriage Bolts (2)
•Plastic Knobs (2)
•“L” Bolt
•Plastic Knob
•Self Tapping Screws (4)
If any of the above parts are missing or damaged, call the pressure washer helpline at
PREPARING PRESSURE WASHER FOR USE
If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the pressure washer helpline at
To prepare your pressure washer for operation, you will need to perform these tasks:
1.Fill out and send in registration card.
2.Attach handle to main unit.
3.Attach chemical reservoir assembly and hose reel to handle.
4.Connect chemical hose to pump.
5.Add oil to engine crankcase.
6.Add fuel to fuel tank.
7.Connect high pressure hose to spray gun and pump.
8.Connect water supply to pump.
9.Attach nozzle extension to spray gun.
10.Select/attach quick connect spray tip to nozzle extension.
Attach Handle
1.Place handle assembly onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 1).
Figure 1 — Attach Handle to Base
Handle
Align Holes 
Handle
Supports
NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.
6
