SpeedClean™ 2200 PSI Pressure Washer
2.Point nozzle down towards a firm surface and press trigger to test spray pattern (Figure 10).
Figure 10 — Testing the Spray Pattern
3.Twisting nozzle adjusts spray pattern from a narrow pattern to a fan pattern (Figure 11).
Figure 11 — Adjusting the Nozzle for Spray Pattern
Clockwise = Narrow Spray | Counterclockwise = Fan |
Pattern | Spray Pattern |
Usage Tips
•For most effective cleaning, keep spray nozzle from 8 to 24 inches away from cleaning surface.
•If you get spray nozzle too close, especially using high pressure mode, you may damage surface being cleaned.
•DO NOT get closer than 6 inches when cleaning tires.
How to Use the Floor and Utility Brushes
NOTE: You must use the adapter to attach the brush to the spray gun.
To attach the floor brush to the gun:
1.Tighten the adapter to the brush extension.
2.Remove nozzle extension from spray gun, if attached.
3.Attach brush extension to spray gun.Tighten by hand.
4.Attach floor brush to brush extension (Figure 13). Tighten by hand.
Figure 13 - Attaching Floor Brush to Spray Gun
NOTE: You must use the adapter to attach the brush extension to the spray gun.
Applying Detergent with the Adjustable Nozzle
IMPORTANT: Use soaps designed specifically for pressure washers. Household detergents could damage the pump.
CAUTION
You must attach all hoses before you start the engine.
•Starting the engine without all the hoses connected and without the water turned ON will damage the pump.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
The floor and utility brushes allow you to scrub surfaces with water filtering through the bristles.
To attach the utility brush to the gun:
1.Tighten the adapter to the brush base.
2.Remove the nozzle extension from the spray gun, if attached.
3.Attach the brush with the adapter to the spray gun. Tighten by hand (Figure 12).
Figure 12 - Attaching Utility Brush to Spray Gun
To apply detergent, follow these steps:
1.Review use of adjustable nozzles.
2.Prepare detergent solution as required by job.
3.Place filter end of chemical injection hose into detergent container.
CAUTION
Keep the chemical injection tube from coming in contact with the hot muffler.
•When inserting the filter into a detergent solution bottle, route the tube so as to keep it from inadvertently contacting the hot muffler.
11
