SpeedClean™ 2200 PSI Pressure Washer
TROUBLESHOOTING
Problem | Cause | Correction | |||
|
|
|
|
| |
| 1. | Nozzle in low pressure mode. | 1. | Pull nozzle backward for high | |
|
|
|
| pressure mode. | |
| 2. | Water inlet is blocked. | 2. | Clear inlet. | |
| 3. | Inadequate water supply. | 3. | Provide adequate water flow. | |
Pump has following problems: | 4. | Inlet hose is kinked or leaking. | 4. | Straighten inlet hose, patch leak. | |
5. | Clogged inlet hose strainer. | 5. | Check and clean inlet hose | ||
failure to produce pressure, erratic | |||||
|
|
| strainer. | ||
pressure, chattering, loss of |
|
|
| ||
6. | Water supply is over 100°F. | 6. | Provide cooler water supply. | ||
pressure, low water volume. | |||||
7. | High pressure hose is blocked or | 7. | Clear blocks in outlet hose. | ||
| |||||
|
| leaks. |
|
| |
| 8. | Gun leaks. | 8. | Replace gun. | |
| 9. | Orifice is obstructed. | 9. | Clean orifice. | |
| 10. | Pump is faulty. | 10. | Contact local service facility. | |
|
|
|
|
| |
| 1. | Detergent siphoning tube is not | 1. | Insert detergent siphoning tube | |
|
| submerged. |
| into detergent. | |
| 2. | Chemical filter is clogged or | 2. | Clean or replace filter/detergent | |
Detergent fails to mix with spray. |
| cracked. |
| siphoning tube. | |
| 3. | Dirty | 3. | See "Check | |
| 4. | Nozzle is in high pressure mode. | 4. | Push nozzle forward for low | |
|
|
|
| pressure mode. | |
|
|
| |||
| Engine speed is too slow. | Move throttle control to FAST | |||
Engine runs good at |
|
| position. If engine still "bogs down", | ||
"bogs" when load is added. |
|
| contact Briggs and Stratton service | ||
|
|
| facility. | ||
|
|
| |||
Pressure washer stops during | Out of fuel. | Fill fuel tank. | |||
operation. |
|
|
|
| |
|
|
|
|
| |
16
