Generac Portable Products 3000 PSI Pressure Washer
TROUBLESHOOTING
Problem | Cause | Correction | ||
| 1. | Low pressure spray tip installed. | 1. | Replace spray tip with high |
|
|
|
| pressure spray tip. |
| 2. | Water inlet is blocked. | 2. | Clear inlet. |
| 3. | Inadequate water supply. | 3. | Provide adequate water flow. |
| 4. | Inlet hose is kinked or leaking. | 4. | Straighten inlet hose, patch leak. |
Pump has following problems: | 5. | Clogged inlet hose strainer. | 5. | Check and clean inlet hose |
|
|
| strainer. | |
failure to produce pressure, |
|
|
| |
|
|
|
| |
erratic pressure, chattering, loss | 6. | Water supply is over 100°F. | 6. | Provide cooler water supply. |
of pressure, low water volume. | 7. | High pressure hose is blocked or | 7. | Clear blocks in outlet hose. |
| ||||
|
| leaks. |
|
|
| 8. | Gun leaks. | 8. | Replace gun. |
| 9. | Spray tip is obstructed. | 9. | Clean spray tip. |
| 10. | Pump is faulty. | 10. | Contact authorized service |
|
|
|
| facility. |
|
|
|
|
|
| 1. | Detergent siphoning tube is not | 1. | Insert detergent siphoning tube |
|
| submerged. |
| into detergent. |
Detergent fails to mix with spray. | 2. | Chemical filter is clogged or | 2. | Clean or replace filter/detergent |
| cracked. |
| siphoning tube. | |
| 3. | Dirty | 3. | See "Check |
| 4. | High pressure spray tip installed. | 4. | Replace spray tip with low |
|
|
|
| pressure spray tip. |
|
|
| ||
Engine shuts down during | Out of gasoline. | Fill fuel tank. | ||
operation. |
|
|
|
|
17
