Engine Maintenance, Ring Maintenance | Briggs & Stratton 1418-2

Generac Portable Products 3000 PSI Pressure Washer

6.Reinstall spray tip and in-line filter into nozzle extension.

7.Reconnect nozzle extension to spray gun.

8.Reconnect water supply, turn on water, and start engine.

9.Test pressure washer by operating with each Quick Connect spray tip.

O–Ring Maintenance

Through the normal operation of your pressure washer, o–rings, which keep the connections of the hoses and spray gun tight and leak–free, may become worn or damaged.

An O-Ring Maintenance Kit is provided with your pressure washer which includes replacement o-rings, rubber washer and water inlet filter. Refer to the instruction sheet provided in the kit to service your unit’s o-rings. Note that not all of the parts in the kit will be used on your unit.

To remove a worn or damaged o–ring; use a small flathead screwdriver to get underneath the o-ring and pry it off.

Pump Maintenance

Changing Pump Oil

Change oil after first 50 hours of operation and then every 200 hours or 3 months, whichever occurs first.

NOTE: When changing pump oil, use only high quality nondetergent 30 weight oil. Use no special additives.

Change pump oil as follows:

1.Clean area around brass oil drain plug at bottom of pump.

2.Remove oil drain plug. Drain oil completely into an approved container.

3.When oil has completely drained, install oil drain plug and tighten firmly.

4.Clean area around pump oil dipstick. Remove dipstick and fill pump with recommended oil to “Full” mark on dipstick.

5.Install pump oil dipstick.

6.Wipe up any spilled oil.

ENGINE MAINTENANCE

See the engine owner’s manual for instructions on how to properly maintain the engine.

CAUTION

Avoid prolonged or repeated skin contact with used motor oil.

•Used motor oil has been shown to cause skin cancer in certain laboratory animals.

•Thoroughly wash exposed areas with soap and water.

KEEP OUT OF REACH OF CHILDREN. DON'T POLLUTE. CONSERVE RESOURCES. RETURN USED OIL TO COLLECTION CENTERS.

14

Image 14

Briggs & Stratton 1418-2 owner manual Engine Maintenance, Ring Maintenance, Pump Maintenance, Changing Pump Oil

Contents

3000PSI Equipment Description Table of ContentsSafety Rules When Transporting or Repairing Equipment High pressure spray may damage fragile items including glass Know Your Pressure Washer Nozzle Extension with Quick Connect Allows you to Preparing Pressure Washer for USE AssemblyCarton Contents Remove Pressure Washer From Carton Add Engine Oil and Fuel Install Oil Dipstick on PumpTo install oil dipstick Connect Hose and Water Supply to Pump Inspect inlet Checklist Before Starting EngineClean if dirty Screen. do not How to Stop Pressure Washer HOW to USE Your Pressure WasherHow to Start Engine Squeeze trigger on spray gun to relieve pressure in hose How to Use Spray Tips Cleaning and Applying Chemical Discharging the warm water onto the ground Pressure Washer RinsingAutomatic Cool Down System Thermal Relief Recommendations SpecificationsGeneral Maintenance Pressure Washer Maintenance Check In-Line Filter Nozzle MaintenanceCheck Gun and Nozzle Extension Purge Pump of Air Contaminants Pump Maintenance Engine MaintenanceRing Maintenance Changing Pump Oil Protecting the Pump Preparing the Unit for StorageStoring the Engine Generac Portable Products 3000 PSI Pressure Washer Troubleshooting Exploded View Unit Parts List Unit Qty.Description Exploded View Pump Pump Head Parts List PumpQty Description Valve Kit Piston Kit Exploded View Unloader Parts List Unloader Service Kits 250-B2327GS Qty Pressure Washer About your equipment warrantyEquipment Consumer Use Commercial Use Portable Generator