Generac Portable Products 3000 PSI Pressure Washer
4.Secure handle to pressure washer using four provided flange nuts.
5.Slowly tip pressure washer back in place and insert
Add Engine Oil and Fuel
•Place pressure washer on a level surface.
•Refer to engine owner’s manual and follow oil and fuel recommendations and instructions.
Install Oil Dipstick on Pump
To install oil dipstick:
1.Make sure unit is on a level surface.
CAUTION
You MUST remove the pump’s shipping cap and install the oil dipstick.
•Failure to do so will void the warranty and damage the pump.
2.Remove and discard shipping cap located on pump (Figure 2).
Figure 2 — Install Oil Dipstick onto the Pump
Remove shipping cap and | Shipping Cap |
install oil dipstick here. |
|
Pump Oil |
|
Dipstick |
|
3.Install oil dipstick.
CAUTION
Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.
•Refer to engine manual for oil and fuel fill information.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
NOTE: Check oil often during engine
Connect Hose and Water Supply to Pump
IMPORTANT: To avoid pump damage, you must assemble the nozzle extension to the spray gun and attach all hoses before you start the engine.
1.Uncoil high pressure hose and attach quick connect end of hose to base of spray gun (Figure 3). Pull down on collar of quick connect, slide onto spray gun and let go of collar. Tug on hose to be sure of a tight connection.
Figure 3 — Connect High Pressure Hose to Spray Gun
Connect high |
pressure hose |
here. |
NOTE: Remove and discard all pump shipping caps before attaching hoses.
7
