Briggs & Stratton 1687077 Installation Instructions, REMOVAL 44” FRAME HUNG COMPONENTS

Installation Instructions							Roller Bar Mower Kit
				K		E		A
		I		D	F	X		U
			J					Y
								V
		C						X	E
	B
A		G	Q	L
				M
				N		D	D		Z
				O					D
				P
						R			F
				S				T
						W		H

Figure 2. Remove Frame Hung	I. Crank & Trunnion Assembly	S. Adjustment Rod
Components	J. Capscrews, 5/16-18 x 1-1/4	T. Rocker Arm Assembly
A. Capscrews, 5/16-18 x 1-1/4	K. Arm	U. Washer, 3/8, Small
B. Washer, 5/16	L. Height of Cut Plate	V. Strap
C. Indicator	M. Lockwasher, 5/16	W. Locknut, 3/8-16
D. Capscrews & Locknuts	N. Nut, 5/16-18	X. Chains, 3 Link
E. Hangers	O. Hair Pin	Y. Upstop
F. Eccentric Nuts	P. Locknuts, 1/2-13	Z. Washers
G. Wheel Bracket Plate, RH	Q. Stop, Height Of Cut
H. Wheel Bracket Plate, LH	R. Clevis Pin

REMOVAL 44” FRAME HUNG COMPONENTS

1.Disconnect hair pin (O, Figure 2) and clevis pin (R) from adjustment rod (S). Remove adjustment rod (S) from rocker arm assembly (T). Reconnect hair pin

(O) and clevis pin (R) into adjustment rod (S) to pre- vent loss.

2.Remove and retain 5/16-18 x 1-1/4 capscrews (A), washer (B) and indicator (C). Remove and discard wheel bracket (G).

3.Remove and retain 5/16-18 x 1-1/4 capscrews (J), arm (K) and crank & trunnion assembly (I). Remove and retain nut (N), lockwasher (M) and height of cut plate (L).

4.Remove and discard 1/2-13 locknuts (P), stop (Q).

5.Remove and discard locknut (W) and wheel bracket

(H).

6.Remove and discard capscrew & nuts (D), washers (Z), hangers (E). Retain the chains (X) and one of the eccentric nuts (F).

6.Remove and retain straps (V), upstop (Z), washers (U), and capscrews (A). Remove and discard rocker arm assembly (T).

2