|
|
|
| E |
|
|
|
|
| F |
|
|
| K |
|
|
|
|
| G |
|
|
|
Normal Removal |
| D |
|
|
|
& Installation | C |
|
|
| |
A | D | C | B | ||
L |
|
| |||
|
|
| |||
H |
|
|
| ||
J |
|
|
| ||
|
| I | L |
|
|
|
|
|
|
| |
|
| A. Hitch Support |
| G. Discharge Tube | |
|
| Assembly |
| H. Wire Form | |
|
| B. Cover |
| I. | Puck |
|
| C. Pin |
| J. Boot | |
|
| D. Hair Pins |
| K. Seal | |
|
| E. Bag |
| L. Frame Spacers | |
|
| F. Grass Bag Hanger |
|
|
Figure 14. Normal Installation & Removal
WARNING
OPERATION WITHOUT BAGGER
For operation without bagger, the mower deflector MUST be properly installed in the down position and retained by the spring latch.
3.Remove and empty bags (E, Figure 10).
4.Lift discharge deflector up (E, Figure 13).
5.Loosen (do not remove) wing nut (B) and lock nut
(C).
6.Slide lower chute (A) off carriage bolt (D) and deflector hinge rod (F).
Bagger Removal
1.Disconnect the discharge tube (G, Figure 14) from boot (J) by moving wire form (H) up and out from metal puck (I). Remove discharge tube (G) from seal (K).
2.Remove hair pin clips (D) and pins (C) then remove cover (B) see Figure 9.
Note: To prevent loss of parts reinstall pins (C) and hair pins (D) in support assembly hinge pivots (E, Figure 9).
12