Briggs & Stratton 1695353 manual Install Baffle and Blade, Assembly

Assembly

B

F

D

G

	H
I	J	D
	K
	L
	Torque Capscrew to
	45-55 ft. lbs. (61-75 Nm)

C

AE

A.Baffle (New)

B.Spacer (New)

C.Carriage Bolts, 5/16-18 x 2 (New)

D. Locknuts, WHIZ Lock,

5/16-18 (New)

E. Carriage Bolt,

5/16-18 x 5/8 (New)

F.Wing Nut Assembly, Large, 5/16-18 (New)

G.Locknut, Center Lock, 5/16-18 (New)

H.Grass Shield (Existing)

I.Blade, High Lift (New)

J.Hex Washer (Existing)

K.Washer (Existing)

L.Capscrew,

7/16-14 x 1-1/4 (Existing)

Figure 3. Baffle Assembly

Install Baffle and Blade

Note: Units with an anti-blowout baffle do not require the Clean Sweep baffle.

1.Remove mower deck. See OPERATOR’S MANUAL.

2.Install notched side of baffle (A, Figure 3) to discharge side of deck securing with 5/16-18 x 2 carriage bolt (C) and 5/16-18 locknut (D). Install 5/16-18 wing nut (F) and locknut (G) to carriage bolt (C) as shown.

3.Secure center of baffle (A) to deck using 5/16-18 x 2 carriage bolt (C), spacer (B) and nut (D). Secure LH end of baffle (A) to deck using 5/16-18 x 5/8 carriage bolt (E) and nut (D).

4.Remove right hand blade (A, Figure 5). Use a block of wood to prevent blade rotation while loosening the capscrew.

5.Reinstall the large washer (B, Figure 6), spring washer (C) and capscrew (D). Use a wooden block (A) to prevent blade rotation while tightening the capscrew (D) to 45-55 ft. lbs. (61-75 Nm).

A

LOOSEN

Figure 4. Blade Removal

A. Blade

B

A

C

D

Figure 5. Blade Installation Mowers

A. 4x4 Wood Block

B. Hex Washer

C. Spring Washer

D. Blade Capscrew

6