INSTALLING THE REAR TABLE
EXTENSION (Fig. Q, R)
1.Insert the two tubes (2) into the rear table extension (1). (Fig. Q)
NOTE: They must be inserted into the back of the extension with the bent end last so that the bar will hold the
extension in place. The two openings on the rear table (4) must line up with the miter gauge slots on the main table.
2.Snap plastic stops (3) over the two rear table extension tubes (2). Make sure the locating pin in the black plastic stops fits into the matching hole in the extension tube. This will 'lock'the tube into the extension. (Fig. Q)
3.Insert the rear table extension tubes
(2)into the two extension tube brackets under the table (5).
Fig. Q
Bent End
/
\
\
Fig. R
INSTALLING THE BLADE (Fig. S, T, U)
i_ WARNING]
To avoid injury from an accidental start, make sure the switch is in the OFF position and the plug is not connected to the power source outlet.
. Remove the table insert (1) by snapping out from the hole (8). Raise the blade arbor to the
maximum height by turning the blade elevation handwheel
clockwise. (Fig. S)
Fig. S
4.Thread the screw (6) through the hole in either side tube with a
screwdriver. NOTE: Only one side is needed to have a screw inserted.
Tighten with a screwdriver, making sure not to overtighten the screw (6). (Fig. R)
