DADOCUTS(FIG. cc, dd)

i,,_, WARNING]

o Only Stackable dado blades can be used on this saw.

o DO NOT use Adjustable or Wobble type dadoes.

o The maximum dado cut width is 1/2 in.

6.Use only the correct number of round outside blades and inside

chippers as shown in the dado set's instruction manual. Blade/chippers must not exceed 1/2 in. total in width.

Fig. cc

NOTE: An optional dado insert plate (part number 308K) is required for this

J

J

-2

procedure.

1.Remove the table insert, saw blade, anti-kickback pawl assembly, blade guard assembly and riving knife assembly for dado cuts ONLY. Reinstall and realign blade guard for all through-sawing operations. Install a dado not exceeding 6 in. in diameter and 1/2 in. in width

2.Install the dado table insert making sure that the rear of the insert is flush with the table. If the dado insert

is not flush with the table, adjust the two bolts on the insert with a 4 mm hex wrench until it is parallel with the table.

3.Instructions for operating the dado is packed with the separately purchased dado set.

4.The arbor (1) on this saw restricts the maximum width of the cut to 1/2 in.

5.It is not necessary to install the outside flange (2) before threading on the arbor nut (3) for the maximum 1/2 in. dado cuts. Make sure that the

arbor nut (3) is tight, and that at least one thread of the arbor sticks out

past the nut.

-----4-----

1

llitl _H

"3

_N

7.Check the saw to ensure that the dado will not strike the housing, insert, or motor when in operation.

i,A WARNING]

For your own safety, always replace

the blade, blade guard assembly,

anti=kickback pawl assembly,

riving knife assembly and table

insert when you finished the dado

operation.

Fig. dd

Dado cut

Page 41
Image 41
Sears 137.28463 DADOCUTSFIG. cc, dd, Do not use Adjustable or Wobble type dadoes, For your own safety, always replace