oThebladebodymustbethinnerthan thethicknessoftherivingknifebut thebladekerfmustbethickerthan
therivingknife.
7.Checktherivingknifeandblade alignmentagainatboth0°and45°.
8.Replacethetableinsert,bladeguard
Fig. X
If the blade is partial to left side:
1.Turn the right adjustment screw (3) counterclockwise and adjust the left side adjustment screw (2) clockwise.
2.Remeasure, as described in steps 4 to 9 in the prior section.
3.When alignment is achieved, turn the right adjustment screw (3) until it touches the pivot rod (4).
Fig. Y
4
BLADE GUARD ASSEMBLY
i_ WARNING]
To avoid possible injury and damage to the workpiece, be sure to INSTALL THE BLADE WITH THE TEETH POINTING TOWARD THE FRONT OF TABLE in the direction of the rotation arrow on the blade guard.
ADDITIONAL BLADE
ADJUSTMENTS (Fig. Y)
NOTE: The adjusting mechanism is located above the blade height adjusting hand wheel under the tabletop. If the front and rear measurements are not the same.
If the blade is partial to right side:
1.Turn the left adjustment screw (2) counterclockwise and adjust the right side adjustment screw (3) clockwise.
2.Remeasure, as described in steps 4 to 9 in the prior section.
3.When alignment is achieved, turn the left adjustment screw (2) until it touches the pivot rod (4).
I,A WARNING l
To avoid injury from an accidental start, make sure the switch is in the OFF position and the plug is disconnected from the power source outlet.
oWhen installing the blade guard, cover the blade teeth with a piece
of folded cardboard to protect yourself from possible injury.
oNever operate this machine without the blade guard in place for all through sawing operations.
Installing the blade guard and
anti=kickback pawl assembly (Fig. Z, AA, BB)
1.Make sure the blade is elevated to
its maximum height and the bevel is set at 0°. Make sure the bevel lock
handle is tight.
2.Take the
