POWER SUPPLY AND MOTOR SPECiFiCATiONS
i,A WARNING ]
To avoid electrical hazards, fire hazards, or damage to the tool, use proper circuit protection. Use a
seperate electrical circuit for your tool. Your table saw is wired at the
factory for 120V operation. Connect to a 120V, 15 Amp circuit and use a 15 Amp time delay fuse or circuit breaker. To avoid shock or fire, if power cord is worn, cut, or damaged in any way, have it replaced immediately.
GROUNDING iNSTRUCTiONS
i,_ WARNING i
This tool must be grounded while
in use to protect the operator from electrical shock.
iN THE EVENT OF A MALFUNCTION OR BREAKDOWN, grounding provides a path of least resistance for electric currents and reduces the risk of electric shock. This tool is equipped with an electrical cord that has an equipment- grounding conductor and a grounding plug. The plug must be plugged into
a matching receptacle that is properly installed and grounded in accordance with all local codes and ordinances.
DO NOT MODIFY THE PLUG PROVIDED. if it will not fit the receptacle, have the proper receptacle installed by a qualified electrician.
iMPROPER CONNECTION of the
equipment grounding conductor can result in risk of electric shock. The
conductor with the green insulation (with or without yellow stripes) is the
equipment grounding conductor. If repair or replacement of the electrical cord or plug is necessary, do not
connect the equipment grounding conductor to a live terminal.
CHECK with a qualified electrician or service person if you do not completely understand the grounding instructions, or if you are not certain the tool is properly grounded.
USE only 3=wire extension cords that have three=pronged grounding plugs with three=pole receptacles that accept the tool's plug. Repair or replace damaged or worn cords
immediately.
Use a separate electrical circuit for your tool. This circuit must not be less than #14 wire and should be protected with a 15 Amp time delay fuse. Before connecting the motor to the power line, make sure the switch is in the off position and the electric current is rated the same as the current stamped on the motor nameplate. Running at a lower voltage will damage the motor.
USE THE PROPER EXTENSION CORD. Make sure your extension cord is in good condition. Use an extension cord heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power, overheating
and burning out of the motor. The table below shows the correct size
to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the cord.
