Speed Clean™ 2300 PSI Pressure Washer
KNOW YOUR PRESSURE WASHER
Read this owner’s manual and safety rules before operating your pressure washer.
Compare the illustrations with your pressure washer to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference.
Spray Gun
Recoil Starter
High Pressure Hose
Fuel Cap
Oil Fill/Dipstick
Throttle Control Lever
Choke Lever
Chemical Injection
Air Filter | Siphon/Filter |
Adjustable Nozzle | High Pressure Outlet |
| |
| & Water Inlet |
Pump equipped with Automatic |
|
Cool Down System |
|
Adjustable Nozzle — Always attached to nozzle extension. Adjustable nozzle allows you to adjust spray pressure and spray pattern.
Air Filter — Dry type filter element limits the amount of dirt and dust that gets in the engine.
Automatic Cool Down System — Cycles water through pump when water reaches
Chemical Injection Siphon/Filter — Use to siphon detergent or other pressure washer chemicals into the low pressure stream.
Choke Lever — Prepares a cold engine for starting.
DataTag (not shown, near rear of base plate) — Provides model, revision and serial number of pressure washer. Please have these readily available if calling for assistance.
Fuel Cap — Fill tank with regular unleaded fuel here. Always leave room for fuel expansion.
High Pressure Hose — Connect one end to water pump and the other end to spray gun.
High Pressure Outlet — Connection for high pressure hose.
Oil Fill/Dipstick — Check and fill with oil here.
Pump — Develops high pressure.
Recoil Starter — Used for starting the engine manually.
Spray Gun — Controls the application of water onto cleaning surface with trigger device. Includes safety latch.
Throttle Control Lever — Sets engine in starting mode for recoil starter and stops a running engine.
Water Inlet — Connection for garden hose.
4