Briggs & Stratton 1909-0 Remove Pressure Washer from Carton, Preparing Pressure Washer for USE

Speed Clean™ 2300 PSI Pressure Washer

IMPORTANT: Read entire owner’s manual before you attempt to assemble or operate your new pressure washer.

REMOVE PRESSURE

WASHER FROM

CARTON

1.Remove the parts bag, accessories, and inserts included with pressure washer.

2.Slice two corners at the end of carton from top to bottom so the panel can be folded down flat.

3.Remove pressure washer from carton.

Carton Contents

Items in the carton include:

•Main Unit

•Handle

•High Pressure Hose

•Spray Gun

•Nozzle Extension

•Safety Goggles

•Oil Bottle

•Parts Bag (which includes the following):

•Owner’s Manual

•Engine Manual

•Owner’s Registration Card

•Handle Attachment Hardware

Attach Handle

1.Place the handle assembly onto the handle supports connected to the main unit. Make sure the holes in the handle align with the holes on the handle supports (Figure 1).

Figure 1 — Attach Handle to Base

Handle

Align Holes

Handle

Supports

NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.

2.Insert the carriage bolts through the holes from the outside of the unit and attach a plastic knob from the inside of the unit (Figure 2).Tighten by hand.

Figure 2 — Secure Handle

PREPARING PRESSURE WASHER FOR USE

If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the pressure washer helpline at 1-800-743-4115. If calling for assistance, please have the model, revision, and serial number from the data tag available.

To prepare your pressure washer for operation, you will need to perform these tasks:

1.Fill out and send in registration card.

2.Attach handle to main unit.

3.Add oil to the engine crankcase.

4.Add fuel to the fuel tank.

5.Connect the high pressure hose to the spray gun and the pump.

6.Connect the water supply to the pump.

7.Attach nozzle extension to spray gun.

3.Insert one of the “L” hooks through the hole just under the billboard on the left side of the handle (viewing from rear of unit). Hold the hook in place with a pliers and attach the locknut with a

7/16” wrench (Figure 3).

Figure 3 — Attach “L” Hooks to Handle

Spray Gun

Hook

Hose Hook

4.Insert the other “L” hook through the hole just above the billboard on the right side of the handle (viewing from rear of unit). Hold the hook in place with a pliers and attach the locknut with a 7/16” wrench (Figure 3).

5