2450 PSI Pressure Washer
O–Ring Maintenance
An
WARNING
The high pressure stream of water that this equipment produces can pierce skin and its underlying tissues, leading to serious injury and possible amputation.
•NEVER repair leaking connections with sealant of any kind. Replace
To remove a worn or damaged
Pump Maintenance
Changing Pump Oil
Change oil every 50 hours or once yearly, whichever occurs first.
NOTE: Purchase a premeasured bottle of pump oil, item number 190586GS, by contacting nearest authorized service center.
Change pump oil as follows:
1.Drain engine oil and fuel from pressure washer.
2.Use 8mm allen wrench to remove black oil cap from pump. It’s found between high pressure outlet and garden hose inlet (Figure 16).
Figure 16 - Changing Pump Oil
Oil Cap |
3.Tilt pressure washer to drain oil into an approved container until it drips slowly from the pump.
4.Tilt pressure washer in opposite direction and empty premeasured pump oil bottle into same opening (a small funnel may be helpful).
5.Install black oil cap on pump and tighten firmly.
6.Set pressure washer in upright position. Add fuel and engine oil.
ENGINE MAINTENANCE
See the engine owner’s manual for instructions on how to properly maintain the engine.
CAUTION
Avoid prolonged or repeated skin contact with used motor oil.
•Used motor oil has been shown to cause skin cancer in certain laboratory animals.
•Thoroughly wash exposed areas with soap and water.
KEEP OUT OF REACH OF CHILDREN. DON'T POLLUTE. CONSERVE RESOURCES. RETURN USED OIL TO COLLECTION CENTERS.
14
