2450 PSI Pressure Washer
TROUBLESHOOTING
Problem | Cause | Correction | ||
| 1. | Nozzle in low pressure mode. | 1. | Pull nozzle backward for high |
|
|
|
| pressure mode. |
| 2. | Water inlet is blocked. | 2. | Clear inlet. |
| 3. | Inadequate water supply. | 3. | Provide adequate water flow. |
| 4. | Inlet hose is kinked or leaking. | 4. | Straighten inlet hose, patch leak. |
Pump has following problems: | 5. | Clogged inlet hose strainer. | 5. | Check and clean inlet hose |
failure to produce pressure, erratic |
|
|
| strainer. |
pressure, chattering, loss of | 6. | Water supply is over 100°F. | 6. | Provide cooler water supply. |
pressure, low water volume. | 7. | High pressure hose is blocked or | 7. | Clear blocks in outlet hose. |
| ||||
|
| leaks. |
|
|
| 8. | Gun leaks. | 8. | Replace gun. |
| 9. | Orifice is obstructed. | 9. | Clean orifice. |
| 10. | Pump is faulty. | 10. | Contact Briggs and Stratton Power |
|
|
|
| Products service facility. |
|
|
|
|
|
| 1. | Detergent siphoning tube is not | 1. | Insert detergent siphoning tube |
|
| submerged. |
| into detergent. |
| 2. | Chemical filter is clogged or | 2. | Clean or replace filter/detergent |
Detergent fails to mix with spray. |
| cracked. |
| siphoning tube. |
| 3. | Dirty | 3. | See "Check |
| 4. | Nozzle is in high pressure mode. | 4. | Push nozzle forward for low |
|
|
|
| pressure mode. |
|
|
| ||
| Engine speed is too slow. | Move throttle control to FAST | ||
Engine runs good at |
|
| position. If engine still "bogs down", | |
"bogs" when load is added. |
|
| contact Briggs and Stratton service | |
|
|
| facility. | |
|
|
| ||
Pressure washer stops during | Out of gasoline. | Fill fuel tank. | ||
operation. |
|
|
|
|
|
|
|
|
|
16
