2450 PSI Pressure Washer
ASSEMBLY
IMPORTANT: Read entire owner’s manual before you attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From Carton
1.Remove parts bag packed with pressure washer.
2.Slice two corners at end of carton from top to bottom so panel can be folded down flat, then remove all packing material.
3.Roll pressure washer out of carton.
Carton Contents
Items in the carton include:
•Main Unit
•Safety Goggles
•Handle
•High Pressure Hose
•Spray Gun
•Adjustable Nozzle Extension
•Oil Bottle
•Parts Bag (which includes the following):
•Owner’s Manual
•Engine Manual
•Maintenance Kit
•Owner’s Registration Card
•Handle Fastening Hardware Kit (which includes):
•Carriage Bolts (2)
•“L” Hooks (2)
•Plastic Knobs (4)
PREPARING PRESSURE WASHER FOR USE
If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the pressure washer helpline at
To prepare your pressure washer for operation, you will need to perform these tasks:
1.Fill out and send in registration card.
2.Attach handle to main unit.
3.Add oil to engine crankcase.
4.Add fuel to fuel tank.
5.Connect high pressure hose to spray gun and pump.
6.Connect water supply to pump.
7.Attach nozzle extension to spray gun.
Attach Handle to Unit
1.Place handle assembly onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 1).
Figure 1 — Attach Handle to Base
Handle
Align Holes 
Handle
Supports
NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.
2.Insert carriage bolts through holes from outside of the unit and attach a plastic knob from inside of unit (Figure 2).Tighten by hand.
Figure 2 — Secure Handle
3.Insert one “L” hook through hole just above billboard on left side of handle (viewing from front of unit). Hold hook in place and attach a plastic knob from inside of unit (Figure 3).Tighten by hand.
Figure 3 — Attach “L” Hooks to Handle
Spray Gun Hook
Hose Hook
4.Insert other “L” hook through hole just below billboard on right side of handle (viewing from front of unit). Hold hook in place and attach a plastic knob from inside of unit (Figure 3).Tighten by hand.
6
