Section 4: Operation
•For maximum rinsing (higher pressure and lower flow), for stubborn or hard to reach surface such as second story surfaces, paint removal, oil stains, rust removal or other stubborn substances (tar, gum, grease, wax, etc.), select red Max ProjectPro™ nozzle (Figure 15).
Figure 15 — Max Nozzle
•To apply detergent, applies project specific cleaners to help break down stubborn dirt and grime on a variety of surfaces, select black ProjectPro™ cleaning detergent nozzle (Figure 16).
Figure 16 — Cleaning Detergent Nozzle
4.Pull back on collar, insert new ProjectPro™ nozzle and release collar.Tug on ProjectPro™ nozzle to make sure it is securely in place.
5.For most effective cleaning, keep ProjectPro™ nozzle from 8 to 24 inches away from cleaning surface. If you get ProjectPro™ nozzle too close, you may damage cleaning surface.
6.DO NOT get closer than 6 inches when cleaning tires.
How to Use the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a rapid circular pattern. Always start the turbo nozzle at a distance, gradually getting closer to the surface until you get the cleaning force you want.
CAUTION
The turbo nozzle produces an extremely high pressure spray which is capable of removing paint and cutting holes through surfaces if held too close.
•Always make sure the surface you will clean will not be damaged by the high pressure spray by testing in a hidden area.
1.Pull back collar on
2.Pull back on collar, insert turbo nozzle and release collar (Figure 17).Tug on turbo nozzle to make sure it is securely in place.
Figure 17 - Attaching Turbo Nozzle to Nozzle Extension
3.For most effective cleaning, keep turbo nozzle from 8 to 24 inches away from cleaning surface. If you get turbo nozzle too close, you may damage cleaning surface.
NOTE: Detergent cannot be applied with the turbo nozzle.
Cleaning and Applying Detergent
IMPORTANT: Use detergents designed specifically
for pressure washers. Household detergents could damage the pump.
CAUTION
You must attach all hoses before you start the engine.
•Starting the engine without all the hoses connected and without the water turned ON will damage the pump.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
To apply detergent follow these steps:
1.Review ProjectPro™ nozzle use.
2.Prepare detergent solution as required by manufacturer.
12
