ASSEMBLY
ASSEMBLY
IMPORTANT: Read entire operator’s manual before you attempt to assemble or operate your new pressure washer.
Unpack the Pressure Washer
1.Remove everything from carton except pressure washer.
2.Open carton completely by cutting each corner from top to bottom.
3.Remove pressure washer from carton.
Carton Contents
Items in the carton include:
•Main unit
•High pressure hose
•Spray gun with quick connect fitting
•Nozzle extension with quick connect fitting
•Handle
•Parts Bag (includes the following):
•Hose fittings
•Quick connects
•Bag containing 5
•Safety goggles
•Operator’s manual
•Engine operator’s manual
•Maintenance kit
•Handle fastening hardware kit (which includes):
•Carriage bolts (2)
•Plastic knobs (2)
If parts are missing or damaged, contact the local Briggs & Stratton service center.
PREPARING PRESSURE WASHER FOR USE
To prepare your pressure washer for operation, you will need to perform these tasks:
1.Attach handle to main unit.
2.Verify oil dipstick has been installed into pump (Figure 2).
Figure 2 — Pump Dipstick
Pump Oil Dipstick |
3.Add oil to engine crankcase.
4.Add fuel to fuel tank.
5.Connect high pressure hose to spray gun and pump.
6.Connect water supply to pump.
7.Attach nozzle extension to spray gun.
8.Select/attach quick connect spray tip to nozzle extension.
Attach Handle
NOTE: All assembly operations given in this section will be described from the perspective of assembling the pressure washer from the rear.
1.Place handle assembly onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 3).
Figure 3 — Attach Handle to Base
Handle
Align Holes 
Handle
Supports
7
