Assembly Section
3
ASSEMBLY
IMPORTANT: Read entire operator’s manual before you attempt to assemble or operate your new pressure washer.
Unpack the Pressure Washer
1.Remove everything from carton except pressure washer.
2.Open carton completely by cutting each corner from top to bottom.
3.Remove pressure washer from carton.
Carton Contents
Items in the carton include:
•Main unit
•High pressure hose
•Handle
•Engine oil (2)
•Spray gun with quick connect fitting
•Nozzle extension with quick connect fitting
•Accessory bag (includes the following):
•Owner’s registration card
•Safety goggles
•Bag containing 5
•Operator’s manual
•Engine operator’s manual
•Handle Fastening Hardware Kit (which includes):
•Carriage Bolts (2)
•Plastic Knobs (2)
If any of the above parts are missing or damaged, call the pressure washer helpline at
To prepare your pressure washer for operation, you will need to perform these tasks:
1.Fill out and send in registration card.
2.Remove and discard tape from domed oil filler cap on top of pump.
3.Attach handle to main unit.
4.Add oil to engine.
5.Add fuel to fuel tank.
6.Connect high pressure hose to spray gun and pump.
7.Connect water supply to pump.
8.Connect nozzle extension to spray gun.
9.Select/attach quick connect spray tip to nozzle extension.
Attach Handle
1.Place handle assembly onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 1).
Figure 1 — Attach Handle to Base
Handle
Align Holes 
Handle
Supports
NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.
2.Insert carriage bolts through holes from outside of unit and attach plastic knob on inside of handles (Figure 2). Tighten by hand.
Figure 2 — Secure Handle
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the
pressure washer helpline at
3. Insert
7
