Briggs & Stratton 20263 manual Assembly, Attach Chemical Hose to Pump, Add Engine Oil and Fuel

Section 3: Assembly

2.Insert carriage bolts through holes from inside of unit and attach plastic knob from outside of unit (Figure 2). Tighten by hand.

Figure 2 — Secure Handle

3.Place accessory tray over holes on handle (viewing from front of unit). Push the tree clips into the holes until they sit flat against the accessory tray (Figure 3).

Figure 3 — Attach Accessory Tray to Handle

4.Insert “L” bolt through hole just below billboard on left side of handle (viewing from rear of unit). Hold hook in place and attach plastic knob from inside of unit (Figure 4).Tighten by hand.

Figure 4 — Attach “L” Bolt to Handle

Attach Chemical Hose to Pump

Attach chemical hose to chemical injection fitting on pump

(Figure 5).

Figure 5 — Attach Chemical Hose to Chemical Injection

Fitting on Pump

Add Engine Oil and Fuel

• Place pressure washer on a level surface.

CAUTION

Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.

•Refer to engine operator’s manual for oil and fuel fill information.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

•Refer to engine operator’s manual and follow oil and fuel recommendations and instructions.

NOTE: Check oil often during engine break–in. Refer to engine operator’s manual for recommendations.

Hose Hook

5.Insert multi–colored ProjectPro™ nozzles and other supplied accessories in spaces provided in accessory tray. See “How to Use Accessory Tray”.

8