Maintenance Section
5
SPECIFICATIONS
Maximum Outlet Pressure . . . . . . . . . . . . . . . 3000 psi Maximum Flow Rate . . . . 2.7 gallons per minute (gpm) Detergent Use detergent approved for pressure washers
Water Supply . . . . . . . . . . . . . . . . Not to Exceed 100°F
Temperature
Automatic Cool . . . . . . . . . . . . . Will cycle when water
Down Systemreaches
GENERAL MAINTENANCE RECOMMENDATIONS
The pressure washer warranty does not cover items that have been subjected to operator abuse or negligence.To receive full value from the warranty, the operator must maintain the pressure washer as instructed in this manual.
NOTE: Should you have questions about replacing components on your pressure washer, please call
•Some adjustments will need to be made periodically to properly maintain your pressure washer.
•All maintenance in this manual and the engine operator’s manual should be made at least once each season.
•Once a year you should clean or replace the spark plug, clean or replace the air filter and check the spray gun and nozzle extension assembly for wear.A new spark plug and clean air filter assure proper
•If equipped with inflatable tires, keep the air pressure at the value marked on the tire or within 15 and 40 psi.
PRESSURE WASHER
MAINTENANCE
Check and Clean Inlet Screen
Examine the screen on the water inlet. Clean it if the screen is clogged or replace it if screen is damaged.
Check High Pressure Hose
The high pressure hose can develop leaks from wear, kinking, or abuse. Inspect the hose each time before using it. Check for cuts, leaks, abrasions or bulging of cover, damage or movement of couplings. If any of these conditions exist, replace the hose immediately.
WARNING
The high pressure stream of water that this equipment produces can pierce skin and its underlying tissues, leading to serious injury and possible amputation.
•NEVER repair high pressure hose. Replace it.
•Replacement hose rating MUST exceed maximum pressure rating of unit.
Check Chemical Injection Hose
Examine the filter on the detergent tube and clean if clogged.The tube should fit tightly on the barbed fitting. Examine the tube for leaks or tears. Replace the filter or tube if either is damaged.
Check Gun and Nozzle Extension
Examine the hose connection to the spray gun and make sure it is secure.Test the trigger by pressing it and making sure it “springs back” into place when you release it. Put the trigger lock in the ON position and test the trigger. You should not be able to press the trigger.
Before Each Use
•Check engine oil level.
•Check water inlet screen for damage.
•Check
•Check high pressure hose for leaks.
•Check chemical injection hose and filter for damage.
•Check spray gun and nozzle extension for leaks.
•Rinse out garden hose to flush out debris.
Check In-Line Filter
Refer to Figure 18 and service the
Figure 18 — Clean In-Line Filter
Filter Screen
Nozzle Extension
15
