Assembly Section
3
ASSEMBLY
IMPORTANT: Read entire operator’s manual before you attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From Carton
1.Remove the parts bag, accessories, and inserts included with pressure washer.
2.Slice two corners at the end of carton from top to bottom so the panel can be folded down flat.
3.Remove pressure washer from carton.
Carton Contents
Items in the carton include:
•Main Unit
•Handle
•High Pressure Hose
•Spray Gun
•Nozzle Extension with Quick Connect Fitting
•Plastic Accessory Tray
•Oil Bottle
•Parts Bag (which includes the following):
•Operator’s Manual
•Engine Operator’s Manual
•Owner’s Registration Card
•Safety Goggles
•Bag containing 4
•Handle/Tray Fastening Hardware Kit (which includes):
•Carriage Bolts (2)
•Plastic Knobs (2)
•Tree Clips (4)
PREPARING PRESSURE WASHER FOR USE
If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the pressure washer helpline at
To prepare your pressure washer for operation, you will need to perform these tasks:
1.Fill out and send in registration card.
2.Attach handle to main unit, then attach accessory tray to handle.
3.Add oil to engine crankcase.
4.Add fuel to fuel tank.
5.Connect high pressure hose to spray gun and pump.
6.Connect water supply to pump.
7.Attach nozzle extension to spray gun.
8.Select/attach quick connect ProjectPro™ nozzle to nozzle extension.
Attach Handle and Accessory Tray
1.Place handle onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 1).
Figure 1 — Attach Handle to Base
Handle
Align Holes 
Handle
Supports
NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.
7
