Briggs & Stratton 20288 manuel dutilisation Assembly Section, Preparing Pressure Washer for USE

Assembly Section

3

ASSEMBLY

IMPORTANT: Read entire operator’s manual before you attempt to assemble or operate your new pressure washer.

Unpack the Pressure Washer

1.Remove everything from carton except pressure washer.

2.Open carton completely by cutting each corner from top to bottom.

3.Remove pressure washer from carton.

Carton Contents

Items in the carton include:

•Main Unit

•Handle

•High Pressure Hose

•Spray Gun

•Adjustable Nozzle Extension

•Oil Bottle

•Parts Bag (which includes the following):

•Operator’s Manual

•Engine Operator’s Manual

•Safety Goggles

•Handle Fastening Hardware Kit (which includes):

•Carriage Bolts (2)

•Plastic Knobs (4)

•“L” Hooks (2)

PREPARING PRESSURE WASHER FOR USE

If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the pressure washer helpline at 1-800-743-4115. If calling for assistance, please have the model, revision, and serial number from the data tag available.

To prepare your pressure washer for operation, you will need to perform these tasks:

1.Attach handle to main unit.

2.Add oil to engine crankcase.

3.Add fuel to fuel tank.

4.Connect high pressure hose to spray gun and pump.

5.Connect water supply to pump.

6.Attach nozzle extension to spray gun.

Attach Handle to Unit

1.Place handle assembly onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 1).

Figure 1 — Attach Handle to Base

Handle

Align Holes

Handle

Supports

NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.

2.Insert carriage bolts through holes from outside of the unit and attach a plastic knob from inside of unit (Figure 2).Tighten by hand.

Figure 2 — Secure Handle

3.Insert one “L” hook through hole just above billboard on left side of handle (viewing from front of unit). Hold hook in place and attach a plastic knob from inside of unit (Figure 3).Tighten by hand.

Figure 3 — Attach “L” Hooks to Handle

Spray Gun Hook

Hose Hook

4.Insert other “L” hook through hole just above billboard on right side of handle (viewing from front of unit). Hold hook in place and attach a plastic knob from inside of unit (Figure 3).Tighten by hand.

7