Section 3: Assembly
2.Insert carriage bolts through holes from outside of unit and attach a plastic knob from inside of unit (Figure 2). Tighten by hand.
Figure 2 — Secure Handle
3.Place accessory tray over holes on handle (viewing from front of unit). Push the tree clips into the holes until they sit flat against the accessory tray (Figure 3).
Figure 3 — Attach Accessory Tray to Handle |
4.Insert “L” hook through hole just above billboard on left side of handle (viewing from front of unit). Hold hook in place and attach a plastic knob from inside of unit (Figure 4).Tighten by hand.
Figure 4 — Attach “L” Hook to Handle
Spray Gun Hook
5.Insert
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
CAUTION
Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.
•Refer to engine operator’s manual for oil and fuel fill information.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
•Refer to engine operator’s manual and follow oil and fuel recommendations and instructions.
NOTE: Check oil often during engine
8
