CleanShot™ 2050 PSI Pressure Washer
Connect Hose and Water Supply to Pump
IMPORTANT: To avoid pump damage, you must assemble the nozzle extension to the spray gun and attach all hoses before you start the engine.
1.Uncoil high pressure hose and attach one end of hose to base of spray gun (Figure 1).Tighten by hand.
Figure 1 — Connect High Pressure Hose to Spray Gun
Connect high pressure
hose here
4.Run water through your garden hose for 30 seconds to clean out any debris.
IMPORTANT: DO NOT siphon standing water for the water supply. Use ONLY cold water (less than 100°F).
5.Connect the garden hose (not to exceed 50 feet in length) to the water inlet.Tighten by hand (Figure 3).
CAUTION
There MUST be at least ten feet of unrestricted garden hose between the pressure washer inlet and any flow shut off device, such as a ‘Y’
•Damage to equipment resulting from failure to follow this instruction will void warranty.
6.Turn ON the water and squeeze the trigger on the gun to purge the pump system of air and impurities.
NOTE: Remove and discard all pump shipping caps before attaching hoses.
2.Attach other end of high pressure hose to high pressure outlet on pump (Figure 2).Tighten by hand.
Figure 2 — Connect High Pressure Hose to Pump
3.Before connecting garden hose to water inlet, inspect inlet screen (Figure 3). Clean screen if it contains debris or have it replaced if damaged. DO NOT RUN PRESSURE WASHER IF INLET SCREEN IS DAMAGED.
Figure 3 — Connect the Garden Hose to Water Inlet
Inspect inlet
screen, DO NOT
use if damaged;
clean if dirty.
WARNING
High pressure spray can cause paint chips or other particles to become airborne.
•Always wear eye protection when using this equipment or in vicinity of where equipment is in use.
•Before starting the pressure washer, be sure you are wearing adequate eye protection.
CHECKLIST BEFORE STARTING ENGINE
Review the unit’s assembly to ensure you have performed all of the following.
1.Check that oil has been added to proper level in the engine crankcase.
2.Add proper gasoline to fuel tank.
3.Check for properly tightened hose connections.
4.Check to make sure there are no kinks, cuts, or damage to high pressure hose.
5.Provide a proper water supply at an adequate flow.
6.Be sure to read “Safety Rules” and “How To Use Your Pressure Washer” before using pressure washer.
7
