CleanShot™ 2050 PSI Pressure Washer
Figure 6 — Adjusting Nozzle for Pressure
Slide nozzle backward | Slide nozzle forward for low |
for High Pressure | pressure mode and |
Mode | detergent application |
2.Point nozzle down towards a firm surface and press trigger to test pattern (Figure 7).
Figure 7 — Testing the Spray Pattern
3.Twisting nozzle adjusts spray pattern from a narrow pattern to a fan pattern (Figure 8).
Figure 8 — Adjusting the Nozzle for Spray Pattern
Rotate nozzle | Rotate nozzle clockwise |
counterclockwise for fan | for narrow spray pattern |
spray pattern |
|
4.For most effective cleaning, keep spray nozzle from 8 to 24 inches away from cleaning surface.
5.If you get spray nozzle too close, especially using high pressure mode, you may damage surface being cleaned.
6.DO NOT get closer than 6 inches when cleaning tires.
Using the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a rapid circular pattern.The high pressure spray is most effective when the tip of the nozzle extension is held between 8 to 24 inches from the surface being cleaned.
CAUTION
The turbo nozzle produces an extremely high pressure spray which is capable of removing paint and cutting holes through surfaces if held too close.
•Always make sure the surface you will clean will not be damaged by the high pressure spray by testing in a hidden area.
To attach the turbo nozzle to the spray gun:
1.Engage safety latch to spray gun trigger.
2.Remove the nozzle extension from the spray gun, if attached.
3.Attach the turbo nozzle extension to spray gun (Figure 9).Tighten by hand.
Figure 9 — Connect Turbo Nozzle Extension to Spray Gun
4.Disengage safety latch to spray gun trigger.
5.Always start the turbo nozzle at a distance, gradually getting closer to the surface until you get the cleaning force you want.
NOTE: Detergent cannot be applied with turbo nozzle.
Using the Utility Brush
The utility brush allows you to scrub surfaces with water filtering through the bristles.
To attach the utility brush to the spray gun:
1.Engage safety latch to spray gun trigger.
2.Tighten the adapter to the brush base.
3.Remove the nozzle extension from the spray gun, if attached.
9
