Briggs & Stratton 2500 PSI owner manual Troubleshooting

Speed Clean™ 2500 PSI Pressure Washer

TROUBLESHOOTING

Problem	Cause		Correction
	1.	Nozzle in low pressure mode.	1.	Pull nozzle backward for high pressure
				mode.
	2.	Water inlet is blocked.	2.	Clear inlet.
Pump has following	3.	Inadequate water supply.	3.	Provide adequate water flow.
	4.	Inlet hose is kinked or leaking.	4.	Straighten inlet hose, patch leak.
problems: failure to
	5.	Clogged inlet hose strainer.	5.	Check and clean inlet hose strainer.
produce pressure, erratic
	6.	Water supply is over 100°F.	6.	Provide cooler water supply.
pressure, chattering, loss
	7.	High pressure hose is blocked or	7.	Clear blocks in outlet hose.
of pressure, low water
		leaks.
volume.
	8.	Gun leaks.	8.	Replace gun.
	9.	Nozzle is obstructed.	9.	Clean nozzle.
	10.	Pump is faulty.	10.	Contact Briggs and Stratton service
				facility.
	1.	Detergent siphoning tube is not	1.	Insert detergent siphoning tube into
		submerged.		detergent.
Detergent fails to mix	2.	Chemical filter is clogged or cracked.	2.	Clean or replace filter/detergent
				siphoning tube.
with spray.
	3.	Dirty in-line filter.	3.	See “Check In-Line Filter” on page 12.
	4.	Nozzle is in high pressure mode.	4.	Push nozzle forward for low pressure
				mode.
Pressure washer stops	Out of gasoline.		Fill fuel tank.
during operation.

15