Speed Clean™ 2500 PSI Pressure Washer
4.Slide the adjustable nozzle forward to low pressure mode. Detergent cannot be applied with the nozzle in high pressure position.
5.Make sure the garden hose is connected to the water inlet. Check that the high pressure hose is connected to the spray gun and the pump. Start the engine.
6.Apply the detergent to a dry surface, starting at lower portion of area to be washed and work upward, using long, even, overlapping strokes.
7.Allow the detergent to "soak in" for
IMPORTANT: You must flush the chemical injection system after each use by placing the filter into a bucket of clean water, then run the pressure washer in low pressure for
Pressure Washer Rinsing
WARNING! Be extremely careful if you must use the pressure washer from a ladder, scaffolding or any other relatively unstable location.When you press the trigger, the recoil from the initial spray could cause you to fall.The high pressure spray could also cause you to fall if you are too close to the cleaning surface.
For Rinsing:
1.Slide the nozzle backward to high pressure, press the trigger and wait for the detergent to clear.
CAUTION! Firmly grasp spray gun with both hands when using high pressure spray to avoid injury if gun kicks back.
NOTE: You can also stop detergent from flowing by simply removing chemical injection hose from bottle.
2.Keep the spray gun a safe distance from the area you plan to spray.
3.Apply a high pressure spray to a small area, then check the surface for damage. If no damage is found, it is okay to continue cleaning.
4.Start at the top of the area to be rinsed, working down with same overlapping strokes as you used for washing and applying detergent.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
10
