4BRIGGSandSTRATTON.com
Assembly
Your generator requires some assembly and is ready
for use after it has been properly serviced with the
recommended fuel and oil level is verified.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-743-4115. If calling for assistance, please have
the model, revision, and serial number from the data
tag available. See Generator Controls and Features
for data tag location.

Unpack Generator

1. Set the carton on a rigid, flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner
from top to bottom.
4. Leave generator on carton to install wheel kit.

Shipment Contents

The generator is supplied with:
• Operator’s manual
• Adapter cord set
• Wheel kit

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road
use.
You will need the following tools to install these
components:
• 13 mm wrench
• Socket wrench with a 13 mm socket
• Pliers
• Safety glasses
Refer to Figure 1 and install the wheel kit as follows:
1. Tip generator so that engine end is up.
2. Slide axle (A) through both mounting brackets.
3. Place a wheel (B) on each side as shown in
Figure 1a.
4. Place a washer (C) on axle and then place an
e-ring (D) in axle groove.
1a
E
GD
B
FA
C
A
B
Figure 1 — Install Wheel Kit
A - Axle
B - Wheel
C - Flat Washer
D - E-Ring
E - Support Leg
F - M8 x 16 mm Capscrews
G - Hex Nuts

Equipment Description

Read this manual carefully and become
familiar with your generator. Know its
applications, its limitations and any hazards
involved.
The generator is an engine–driven, revolving field,
alternating current (AC) generator. It was designed to
supply electrical power for operating compatible
electrical lighting, appliances, tools and motor loads.
The generator’s revolving field is driven at about
3,600 rpm by a single-cylinder engine.
Every effort has been made to ensure that the
information in this manual is both accurate and current.
However, the manufacturer reserves the right to
change, alter or otherwise improve the generator and
this documentation at any time without prior notice.
The Emission Control System for this generator is
warranted for standards set by the Environmental
Protection Agency and the California Air Resources
Board.
• DO NOT exceed the generator’s wattage/ amperage capacity.
See Don’t Overload Generator in the Operation section.
Exceeding generators wattage/amperage capacity
can damage generator and/or electrical devices
connected to it.
NOTICE
• Always wear eye protection when installing/removing e-rings.
E-rings can cause eye injury.
E-rings can spring back and become
airborne when installing or removing.
CAUTION