Briggs & Stratton 30253 Assembly, Before Starting the Engine, Unpacking the Generator

ASSEMBLY

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at

1-800-743-4115. If calling for assistance, please have the model, revision, and serial number from the serial number label available. See “Know Your Generator” for location.

Unpacking the Generator

1.Set the carton on a rigid flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install handle.

Attach Handle to Unit

1.Place handle assembly onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 1).

Figure 1 — Attach Handle to Base

Handle

Align Holes

Handle

Supports

NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.

ASSEMBLY

2.Insert carriage bolts through holes from outside of the unit and attach a plastic knob from inside of unit (Figure 2).Tighten by hand.

Figure 2 — Secure Handle

BEFORE STARTING THE ENGINE

Add Engine Oil

• Place generator on a level surface.

CAUTION

Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.

•Refer to engine operator’s manual for oil and fuel fill information.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

•Use a long neck funnel OR remove the fuel tank as described in “Fuel Tank”, when adding or changing oil.

•Refer to engine operator’s manual and follow oil recommendations and instructions.

NOTE: Check oil often during engine break–in. Refer to engine operator’s manual for recommendations.

NOTE: The generator assembly rotates on a prelubricated and sealed ball bearing that requires no additional lubrication for the life of the bearing.

6