SPECIFICATIONS

ENGINE TECHNICAL

INFORMATION

This is a single cylinder, overhead valve(OHV), air cooled engine. It is a low emissions engine.

In the State of California, Model Series 200000 engines are certified by the California Air Resources Board to meet emissions standards for 250 hours. Such certification does not grant the purchaser, owner or operator of this engine any additional warranties with respect to the performance or operational life of this engine.The engine is warranted solely according to the product and emissions warranties stated elsewhere in this manual.

Power Ratings

*The power ratings for an individual engine model are initially developed by starting with SAE (Society of Automotive Engineers) code J1940 (Small Engine Power & Torque Rating Procedure) (Revision 2002-05). Given both the wide array of products on which our engines are placed, and the variety of environmental issues applicable to operating the equipment, it may be that the engine you have purchased will not develop the rated horsepower when used in a piece of power equipment (actual “on-site” power).This difference is due to a variety of factors including, but not limited to, the following: differences in altitude, temperature, barometric pressure, humidity, fuel, engine lubrication, maximum governed engine speed, individual engine to engine variability, design of the particular piece of power equipment, the manner in which the engine is operated, engine run-in to reduce friction and clean out of combustion chambers, adjustments to the valves and carburetor, and other factors.The power ratings may also be adjusted based on comparisons to other similar engines utilized in similar applications, and will therefore not necessarily match the values derived using the foregoing codes.

PRODUCT

SPECIFICATIONS

Generator Specifications

Starting Wattage

.8,550 Watts

Wattage

5,550 Watts

Rated AC Load Current:

 

At 120 Volts

. .46.2 Amps

At 240 Volts

. .23.1 Amps

Phase

. . . .1–phase

Rated Frequency

. . .60 Hertz

Fuel Capacity

7 U.S. gallons

Shipping Weight

. . . .140 lbs.

Engine Specifications

Gross* Horsepower . . . . . . . . . . . . . . . . . . 10 at 3600 rpm Bore . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.12 in. (79mm) Stroke . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.44 in. (62mm) Displacement . . . . . . . . . . . . . . . . . . . . . . 18.64 in. (305 cc)

Spark Plug

Type: . . . . . . . . . . . . Champion RC12YC or Equivalent

Set Gap To: . . . . . . . . . . . . . . . . . . . 0.030inch (0.76mm) Armature Air Gap: . . . . . . . 0.008-0.012 in. (0.20-0.30mm)

Valve clearance with valve springs installed and piston 1/4 in. (6 mm) past top dead center (check when engine is cold).

Intake . . . . . . . . . . . . . . . . . 0.004-0.006 in. (0.10-0.15 mm) Exhaust . . . . . . . . . . . . . . . . 0.004-0.006 in. (0.10-0.15 mm) Oil Capacity . . . . . . . . . . . . . . . . . . .28 Ounces (.83 Liters)

NOTE: For practical operation, the generator load should not exceed 85% of rated wattage. Engine gross horsepower will decrease 3-1/2% for each 1,000 feet (300 meters) above sea level and 1% for each 10° F (5.6° C) above 77° F

(25° C). It should operate satisfactorily at an angle up to 15°.

13

Page 13
Image 13
Briggs & Stratton 30325 Engine Technical Information, Product Specifications, Power Ratings, Generator Specifications