Briggs & Stratton 30325 manual Assembly, Unpack the Generator, Install Wheel Kit

ASSEMBLY

ASSEMBLY

Refer to Figure 1 and install the wheel kit as follows:

1.Tip generator so that engine end is up.

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at

1-800-743-4115. If calling for assistance, please have the model, revision, and serial number from the data tag available. See “Know Your Generator” for data tag location.

Unpack the Generator

1.Set the carton on a rigid flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install wheel kit.

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use. You will need the following tools to install these components:

•2 - 13mm wrenches

•Socket wrench with a 13mm socket

•Pliers

•Safety glasses

Figure 1 — Install Wheel Kit

2.Slide axle through both mounting brackets.

3.Place a wheel on each side with raised hub inboard.

4.Place a washer on axle and then place an e-ring in axle groove.

5.Install e-ring with pliers, squeezing from top of e-ring to bottom of axle.

CAUTION

E-rings can cause eye injury.

E-rings can spring back and become airborne when installing or removing.

• Always wear eye protection when installing/removing e-rings.

6.Repeat step 4 and 5 to secure second wheel.

7.Tip generator so that engine side is down.

8.Line up holes in support leg with holes in generator frame.

9.Attach support leg using 2 capscrews (M8 x 16 mm) and 2 hex nuts.Tighten with a 13mm socket wrench and 13mm wrench.

10.On support leg end of generator, slide handle onto center of top of frame.

Capscrew
Nut
Handle
		Washer
	Axle
Support Leg	Capscrew
Nut	Wheel	E-Ring
	6