MAINTENANCE

CLEANING DEBRIS

CAUTION: Do not use water to clean engine parts. Water could contaminate fuel system. Use a brush or dry cloth.

Daily or before every use, clean accumulated debris from engine. Keep linkage, springs and controls clean. Keep area around and behind muffler free of any combustible debris.

Engine parts should be kept WARNING clean to reduce the risk of

overheating and ignition of accu- mulated debris. This is especial- ly important if cutting tall grass.

ROTATING

REWIND

STARTER

GUARD

Finger Guard or Rotating Screen

CLEAN

Linkage, Springs and Controls

SPARK

ARRESTER

CLEAN

Muffler and Spark Arrester

ADJUSTMENTS

CONTROL ADJUSTMENTS

WARNING

Prevent unintentional starting.

Before performing adjustments:

Remove spark plug wires from spark plugs.

Disconnect battery at negative terminal (only engines with electric start).

TO ADJUST REMOTE CHOKE CONTROL

 

PULL

CHOKE

TO CHOKE

 

CLOSED

 

 

WIRE AND

 

CASING

 

CASING CLAMP SCREW

[1]Remove air cleaner.

[2]Move choke control to CHOKE or START position. (Carburetor choke should be completely closed.)

[3]If not, loosen casing clamp screw.

[4]Then move casing, wire and engine choke lever in direction shown until choke is completely closed.

[5]Tighten casing clamp screw. Replace air cleaner.

14

Page 14
Image 14
Briggs & Stratton 350700, 303700, 294700, 290700 Control Adjustments, Cleaning Debris, To Adjust Remote Choke Control