Installation
Equipment Description
This product is intended for use as an optional home generator system which provides an alternate source of electric power and to serve loads such as heating, refrigeration systems, and communication systems that, when stopped during any power outage, could cause discomfort or inconvenience. This product does not qualify for emergency standby as defined by NFPA 70 (NEC).
Customer Responsibilities
•Read and follow the instructions given in the Operator’s Manual, especially the section regarding selecting essential circuits.
•Follow a regular schedule in maintaining, caring for and using your home generator, as specified in the Operator’s Manual.
Installer Responsibilities
•Read and observe the safety rules.
•Install only an UL approved transfer switches that is compatible with the home generator.
•Read and follow the instructions given in this Installation and
IMPORTANT: The system is equipped with a water heater that is activated when ambient temperature is less than 80°F AND utility power is present at the transfer switch.
Unpacking Precautions
The unit is shipped ready for installation on a prepared reinforced cement slab or engineered base. Avoid damage from dropping, bumping, collision, etc. Store and unpack carton with the proper side up, as noted on the shipping carton.
Delivery Inspection
After removing the carton, carefully inspect the home generator for any damage that may have occurred during shipment.
IMPORTANT: If loss or damage is noted at time of delivery, have the person(s) making delivery note all damage on the freight bill and affix his signature under the consignor’s memo of loss or damage. If loss or damage is noted after delivery, separate the damaged materials and contact the carrier for claim procedures. Missing or damaged parts are not warranted.
Shipment Contents
The home generator system is supplied with:
•Home generator
•
•
•
•Installation and
•Operator’s manual
•Engine operator’s manual
•Installation checklist
•Two access door keys
•One spare 15A fuse
•10 Pole control panel connector
•Remote LED indicator kit (red LED/plate/screws)
Not Supplied:
•650 CCA starting battery (NOT
•Connecting wire and conduit
•Fuel supply valves/plumbing
Required Specialty Tools/Equipment
•Two 60” lengths of 2” Schedule 40 pipe (NOT conduit)
•Lifting straps, chains or cables
•Hole punches for 7 ga steel
•Torque screwdriver, 5 to 50
•Ignition Timing Light
•Air Fuel Ratio Meter (O2 Sensor and Analyzer)
