Liquid Cooled Models only | Briggs & Stratton 5900624, 5901170

Features & Controls

LIQUID COOLED MODELS ONLY

Controls

CONTROL FUNCTIONS

The information below briefly describes the function of individual controls. Starting, stopping, driving, and mowing require the combined use of several controls applied in specific sequences. To learn what combination and sequence of controls to use for various tasks see the OPERATION section.

Ground Speed Levers

These levers control the ground speed of the rider. The left lever controls the left rear drive wheel and the right lever controls the right rear drive wheel.

Moving a lever forward increases the FORWARD speed of the associated wheel, and pulling back on a lever increases the REVERSE speed.

Note: The further a lever is moved away from the neutral position the faster the drive wheel will turn.

See the Operating the Zero Turn Rider section for steering instructions.

16

Seat Adjustment Lever

The seat can be adjusted forward and back. Move the lever towards the left, position the seat as desired, and release the lever to lock the seat in position.

Ignition Switch

The ignition switch starts and stops the engine, it has three positions:

OFF	Stops the engine and shuts off the
	electrical system.
RUN	Allows the engine to run and powers
	the electrical system.
START	Cranks the engine for starting.

NOTE: Never leave the ignition switch in the RUN position with the engine stopped–this drains the battery.

www.ferrisindustries.com

Image 18

Briggs & Stratton 5900624, 5901170, 5900625, 5900629, 5900670 manual Liquid Cooled Models only

Contents

Briggs & Stratton Yard Power Products Group DescriptionModel Number Date Purchased Table of Contents Operating Safety Slope Operation Roll Bar Use Fuel and Maintenance Operation TrainingPreparation Children Slope OperationTowed Equipment RIDE-ON Units Emissions Service and Maintenance Maintenance and StorageSafe Handling of Gasoline Roll BAR Instructions Operational Warnings Inspection and Maintenance of the Roll BAR Seat Belt Identification Numbers Identification Safety Decals Safety Interlock System North American Safety IconsOperational Safety Checks AIR Cooled Models only Seat Adjustment LeverIgnition Switch Control Functions Parking Brake PTO Power Take Off SwitchHour Meter / Maintenance Reminder Throttle Control Liquid Cooled Models only Water Temperature Gauge General Operating Safety Checks Before StartingNever allow passengers to ride on the unit Starting the Engine Stopping the RiderPushing the Rider by Hand Forward Travel Practice Zero Turn Driving PracticeSmooth Travel Reverse Travel Practice Executing Turns Practice Turning Around a Corner Practice Turning In PlaceExecuting an End-Of-Row Zero Turn Turning Height of Grass MowingMowing Recommendations Tall Grass Requires Incremental Cutting Mowing Patterns When and How Often to MowMowing Methods Proper Broadcast Mowing Attaching a Trailer Proper Mulching To raise the roll bar Raise & Lower the Roll BARTo lower the roll bar Keep roll bar in the raised position and use seat belt Temporary Storage 30 Days Or Less StorageStarting After Long Term Storage Long Term Storage Longer Than 30 Days Engine Maintenance Safety ItemsRider Maintenance Before Every Spring Each 100 250 Fall Use Hours Fuel Filter Check Tire PressuresChecking / Adding Fuel Change OIL & Filter Air Cooled Models Check Hydraulic OIL LevelChange Hydraulic OIL Filter Liquid Cooled Models Change Engine Coolant Clean Radiator & Screen Check Engine Coolant LevelPressurized System Oil LubricationGrease Pivots Battery Maintenance Cleaning the Battery and Cables Air Cooled ModelsCleaning the Battery and Cables Liquid Cooled Models Servicing the Mower Blades Removing the Blade Troubleshooting Warning Troubleshooting the Rider Troubleshooting the Mower Rider Troubleshooting Troubleshooting Common Cutting Problems Streaking Seat Adjustment Ground Speed Control Lever AdjustmentSpeed Balancing Adjustment Adjustment Linkage Rod Neutral AdjustmentRETURN-TO-NEUTRAL Adjustment RH side shown Parking Brake Adjustment Parking Brake Adjustment Brake Spring Adjustment Nut Suspension Adjustment To adjust the spring pre-loadTo adjust the upper mounting position Mowing Height Adjustment Foot Pedal AdjustmentTo adjust pedal position Deck Lift ROD Timing Adjustment Inner RodOuter Rod Deck Leveling Adjustment Deck Lift Spring4 Locations Hydraulic Pump Drive Belt Replacement Mower Belt Replacement Deck Charging a Completely Discharged Battery Battery ServiceChecking Battery Voltage Jump Starting With Auxiliary Booster Battery This HOOK-UP for Negative Ground Vehicles Make Certain Vehicles do not TouchJump Starting Chassis DimensionsEngine Transmissions Ferris Limited Warranty Tractor Belts and BladesHP Briggs & Stratton Mower Deck