Operating the Mower
STARTING THE ENGINE
NOTE - The procedures outlined within this section are general guidelines, and are in no way meant to replace or supercede engine manufacturer's operating instruc- tions. In order to obtain optimum performance from your engine, refer to your engine manual.
Before Starting Engine:
•Be sure that the unit is completely assembled, all fas- teners are tightened securely, and all safety guards and components are in place.
•Be sure to check engine's oil and gasoline*. (See engine manual for recommended oil and gasoline specifications.) Never check the engine while it is running or while you are smoking. Check only when engine is cold.
*All machines are shipped without oil or gasoline unless otherwise noted.
To Start Engine:
Recoil Start -
•Open fuel valve, located at bottom of fuel tank by turning knob counterclockwise.
•Set throttle control past the “START” position (fully Right to the double lines) to engage choke.
•Turn key on dash panel to “RUN” position.
•Grasp recoil handle and pull cord briskly. (You may have to pull several times before engine starts. If engine fails to start within a reasonable number of attempts, discontinue and check engine manual for further instructions.)
NOTE: Be sure recoil cord retracts fully into recoil unit. A slack recoil cord can cause serious personal injury and/or damage to unit.
Electric Start - (Optional)
•Open fuel valve, located at bottom of fuel tank by turning knob counterclockwise.
•Set throttle control past the “START” position (fully Right to the double lines) to engage choke.
•Turn ignition key on dash panel past “RUN” position to “START” to engage starter. (If engine fails to start within a reasonable period of time - generally
To Shut Engine Down:
•Allow engine to idle for
•Set throttle control down to “SLOW” position.
•Turn key to “OFF” position.
NOTE: If you experience problems with your engine that cannot be satisfactorily resolved by following the instruc- tions contained within the engine manual, contact your local engine dealer. All engine service, warranty or oth- erwise, is required to be performed by a manufacturer- authorized service center.
ENGAGING THE TRANSMISSION
Your Field & Brush mower is equipped with a rugged hydrostatic transmission. The mower can be operated at variable speeds in both forward and reverse directions. Please read the following instructions in order to acquaint yourself with the mowers controls for safe oper- ation.
The traction drive system is engaged or disengaged through the Traction Drive control lever (Figure 4), locat- ed on the right side of the machine, when standing at the Operator's Controls.
•Engage the traction drive by moving the control lever to the DRIVE position. The brush mower can now be moved using the Traction Drive Controls.
Figure 4 - Traction Drive / Freewheel Control
7
