APPLYING INSTALLATION FINS |
|
| $VUUPMFOHUIVTJOH | |
|
| |||
A. Cut the fins to length. Using the following | A" |
| HJWFO | GPSNVMB |
formula, cut the fins to length, making sure |
|
|
| |
the end cut is square on both ends. |
|
|
|
|
|
|
|
|
Heads and Sills: Length = Frame width +
Jambs: Length = Frame height +
Jambs, if there is no fin at the sill: Length = Frame height +
Combinations: Length = Combination height +
B. Notch the ends of the fins. Measure and | B# | |
| ||
mark |
| |
a hacksaw, cut the fin receptor leg at the mark. |
| |
Finish removing the bottom receptor legs by |
| |
scoring the fin with a utility knife and snapping it | ||
off the fin. | ||
|
Note: When using fins on all four sides, all ends must be notched. If no fin is used at the sill, DO NOT notch the bottom of the jamb fins.
'SBNFSFDFQUPSMFH
C.Install the two side fins into the top of the frame jamb grooves located on the side frame members of the door. Slide the fins into place.
Note: Spray a solution of water and soap on the frame jamb grooves to reduce sliding friction.
C$
D.Install and slide the top fin into the frame head groove located in the top frame member.
Note: The top fin must overlap the exterior of the side fins.
'SBNFIFBEHSPPWF
D%
C$
D%
'SBNF
HSPPWF
*OTUBMMBUJPO | D% | *OTUBMMBUJPO |
mO |
| mO |
'SBNF
HSPPWF
'SBNFKBNCHSPPWF
4*%&7*&8 | 4*%&7*&8 |
3FHVMBS'JO | 0GGTFU'JO |
E. Apply a bead of sealant where the fins overlap. Pump extra sealant into the cavity created by the two overlapping fins.
1VNQFYUSB
TFBMBOUIFSF
F. When applying fins to mulled products, place a line of | E& | |
sealant from the exterior face of the fin to the exterior of the | ||
| ||
door frame at the mullion joint. |
|