Pella 803V0102 3SETTING AND FASTENING THE DOOR, Yufsjps, 1SFESJMMFE
QBOFM
SFUBJOFS
IPMFT

3SETTING AND FASTENING THE DOOR

A.Place three 3/8" beads of sealant. The first bead should be approximately 3/4" from the exterior of the rough opening, the second 2-1/2" in from the first bead of sealant.

OX/XO doors only: Place a third bead of sealant in the groove of the sill support or 1/4" from the exterior edge of the wood blocking.

TWO OR MORE PEOPLE WILL BE REQUIRED FOR THE

FOLLOWING STEPS.

3A"

B. Insert the door from the exterior of the building.		#3B
DO NOT slide the bottom of the door into the
opening. Sliding will damage the sealant lines. Place
the bottom of the door at the bottom of the
opening, then tilt the top into position.
Center the door between the sides of
the opening to allow equal clearance for
shimming, and insert one roofing nail
in the first hole from the corner on each	3B#
end of the top nailing fin (see inset).
These are used to hold the door in place
while shimming it plumb and square.

&YUFSJPS

C.Plumb and square door. Insert shims, as necessary, between the door and the sides of the rough opening starting up 6" from the bottom of the door. Keep shims back 1/2" from interior face of window.

Note: DO NOT shim above the door. DO NOT OVER SHIM.

D. Fasten the door to the opening

by driving 2" galvanized roofing

nails into each pre-punched hole 3D% in the nailing fin.

Interior

3C

E.Install roller retainers. Position and secure the two roller retainers provided by drilling pilot holes through the pre-drilled holes into the sill support. Apply sealant to the holes and insert screws as specified below:

Aluminum sill support: 9/64" pilot holes, # 8 x 3/4" thread-cutting screws (provided).

Wood blocking: 1/8" pilot holes, #8 x 2-1/2" flat-head wood screws (provided).

'JYFE 1BOFM	5ISFTIPME
3E&
1SFESJMMFE QBOFM SFUBJOFS IPMFT