2.8 HYDRAULIC SAFETY

2.9 SAFETY DECALS

The hydraulic system of your Log Splitter requires careful inspection along with the mechanical parts. Be sure to replace frayed, kinked, cracked or otherwise damaged hydraulic components. Just because it isn’t leaking today doesn’t mean that it will not fail tomorrow.

Fluid escaping from a very small hole can almost be invisible. Do not check for leaks with your hand. Escaping fluid under pressure can have sufficient force

to penetrate skin causing serious personal injury or even death. Leaks can be detected by passing a piece of cardboard or wood over the suspected leak and looking for discoloration.

If injured by escaping fluid, see a doctor at once. Serious infection or reaction can develop if proper medical treatment is not administered immediately.

Should it become necessary to loosen or remove any hydraulic fitting or line, be sure to relieve all pressure by shutting off the engine and moving the control handle back and forth several times.

DO NOT remove the cap from the hydraulic tank or reservoir while your Log Splitter is running. Hot oil under pressure could result in serious injury.

The pressure relief valve on your Log Splitter is preset at the factory. DO NOT adjust the valve. Only a qualified service technician should perform this adjustment.

2.9SAFETY DECALS

ALWAYS REPLACE

MISSING OR

DAMAGED DECALS

WARNING

1.READ AND UNDERSTAND OPERATOR’S MANUAL THOROUGHLY BEFORE OPERATION. FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY.

2.KEEP ALL SHIELDS IN PLACE.

3.KEEP HANDS, FEET AND CLOTHING AWAY FROM POWER DRIVEN PARTS.

4.ALWAYS WEAR SAFETY GLASSES AND SAFETY SHOES DURING OPERATION.

5.ALWAYS OPERATE OUT-OF-DOORS WITH GOOD VENTILATION.

6.ALWAYS STOP ENGINE AND REMOVE SPARK PLUG WIRE BEFORE PERFORMING MAINTENANCE OPERATIONS.

7.ALWAYS SHUT OFF ENGINE WHEN LEAVING LOG SPLITTER UNATTENDED, EVEN FOR A SHORT PERIOD OF TIME.

8.ONLY ONE PERSON SHOULD LOAD AND OPERATE THE LOG SPLITTER. KEEP ALL OTHERS CLEAR DURING OPERATION.

NEVER ALLOW ONE PERSON TO OPERATE VALVE WHILE ANOTHER IS POSITIONINGTHE LOG.

9.ALWAYS POSITION LOG WITH HANDS ON THE SIDES OF LOG. KEEP HANDS CLEAR OF ENDS.

10.KEEP ALL CHILDREN AWAY FROM THE LOG SPLITTER.

11.DO NOT STEP OVER THE LOG SPLITTER.

12.ONLY USE HANDS TO OPERATE THE CONTROL VALVE.

13.DO NOT OPERATE THE LOG SPLITTER WHILE UNDER THE INFLUENCE OF ALCOHOL, DRUGS OR MEDICATION.

14.ALWAYS OPERATE THE LOG SPLITTER ON LEVEL, DRY, NON-SLIPPERY SURFACES. KEEP OFF SLOPES.

15.KEEP WORK AREA CLEAR OF SPLIT WOOD, DEBRIS OR OTHER OBSTACLES.

16.ALWAYS STAY IN THE OPERATOR ZONE WHEN USING THE LOG SPLITTER.

17.ALWAYS SPLIT WOOD IN THE DIRECTION OF THE GRAIN ONLY.

18.DO NOT ADD GASOLINE WHILE THE ENGINE IS HOT OR RUNNING. ALLOW ALL SPILLED GAS TO EVAPORATE BEFORE USING LOG SPLITTER.

Part No. DL51-1-57

Part No. DL51-1-32

Location: Top, forward section of hydraulic

Location: Top of hydraulic cylinder

cylinder

 

7

Page 9
Image 9
Briggs & Stratton T22B & T22H manual Hydraulic Safety Safety Decals, Always Replace Missing or Damaged Decals