LIGHTING THE SIDE BURNER:
1.Open lid to the side burner before lighting.
2.Turn on the side burner by pressing in and rotating the control knob to the HIGH position.
3.Press and hold the igniter button on the main control panel for
4.If burner does not ignite immediately, turn the burner control knob to OFF and wait 5 minutes for gas to evacuate the grill. Repeat steps 1 through 4 until burner ignites.
5.If burner does not ignite using the push button igniter wait 5 minutes, see "Match Lighting the Side Burner" section.
MATCH LIGHTING THE SIDE BURNER:
1.Open lid before lighting.
2.Turn the burner control knob to OFF.
SIDE BURNER LIGHTING INSTRUCTIONS:
1.Read and follow all warnings and instructions in owner’s manual before lighting.
2.Open lid before lighting side burner.
3.Make sure all control knobs are in the OFF position.
4.Push and turn side burner control knob to HIGH.
5.Press the electronic igniter and hold for
MAXIMUM SIDE BURNER LOAD = 15 lbs.
6.If burner does NOT ignite immediately, turn control knob to OFF, wait 5 minutes to allow gas to dissipate and repeat lighting procedure.
7.Refer to owner’s manual for match lighting procedure.
8.For assistance, call
9.To turn off, turn control knob clockwise until it locks in OFF position.
3. Strike and place a match approximately 1/2" (2 to 3 cm) from the burner.
4.Turn on the side burner control knob to the HIGH position. The burner should light immediately.
5.If the burner does not ignite immediately, turn the control knob to OFF and wait 5 minutes for gas to evacuate the grill. Repeat Steps 1 through 5 until the burner ignites.
6.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See “Trouble Shooting” section of this manual.
NOTE: Observe flame height when lit: Flame should be a Blue/Yellow color approximately 1” high when burner is on “High.”
TURNING OFF THE GRILL:
1.Turn OFF the LP tank valve.
2.Turn all burner control knobs to the OFF position.
1”
.5”
0”
NOTE: Turn off LP cylinder first to prevent gas from being left in the system under pressure.
CAUTION!
•The LP tank valve should always be in the off, or closed, position when the grill is not in use.
To turn off the LP tank valve, 
turn knob clockwise until it stops.
10
