Brinkmann 2500 owner manual Grease Tray Bracket Grill Body

Grease Tray Bracket

Grill Body

GRILL LIGHTING INSTRUCTIONS:
1.	Read and follow all warnings and instructions	5.	Press the electronic igniter and hold for 3-5	7.	Repeat Steps 4-6 for lighting each burner. Always
	in owner’s manual before lighting.		seconds to light burner.		use electronic igniter for lighting each burner.
2.	Open lid before lighting burner.	6.	If burner does NOT ignite immediately, turn control	8.	Refer to owner’s manual for match lighting procedure.
3.	Make sure all control knobs are in the OFF position.		knob to OFF, wait 5 minutes to allow gas to	9.	For assistance, call 1-800-527-0717.
4.	Select the burner to be lit. Push and turn the control		dissipate and repeat lighting procedure.	10. To turn off, turn control knobs clockwise until it locks
	knob of that burner to HIGH.				in OFF position.

FOR OUTDOOR USE ONLY

Igniter Button Cap

			GRILL LIGHTING INSTRUCTIONS:
		1.		Read and follow all warnings and instructions	5. Press the electronic igniter and hold for 3-5	7.	Repeat Steps 4-6 for lighting each burner. Always
				in owner’s manual before lighting.	seconds to light burner.		use electronic igniter for lighting each burner.
			2.	Open lid before lighting burner.	6. If burner does NOT ignite immediately, turn control	8.	Refer to owner’s manual for match lighting procedure.
3.				Make sure all control knobs are in the OFF position.	knob to OFF, wait 5 minutes to allow gas to	9.	For assistance, call 1-800-527-0717.
4.				Select the burner to be lit. Push and turn the control	dissipate and repeat lighting procedure.	10. To turn off, turn control knobs clockwise until it locks
				knob of that burner to HIGH.			in OFF position.
		OFF		OFF		OFF	OFF
	HIGH			HIGH	HIGH		HIGH
		LOW		LOW	FOR OUTDOOR USE ONLY	LOW	LOW

Step 5

Attach the grease tray bracket onto the back cart panel by inserting the three tabs into the slots on the back cart panel.

Note: When performing Step 6, lift grill body from front and rear panels to avoid injury to hands and fingers.

Step 6

With the help of a friend, place grill body assembly on grill cart. Grill body will rest on upper side sections of cart. Align bolt holes located on the outside of the grill body assembly. Secure using four M6 X12mm bolts. At this point, fully tighten four bolts holding back panel from Step 4.

Note: To install battery, unscrew igniter button cap. Insert battery with positive end towards button. Replace igniter button cap.

22