HOSE AND REGULATOR:

HOSE AND REGULATOR:

Your fryer is equipped with a Type 1 connection device with the following features:

1.The system will not allow gas flow from the cylinder until a positive connection to the valve has been made.

NOTE: The cylinder valve must be turned off before any connection is made or removed.

2. A thermal device that will shut off the gas flow if the device is subject to temperatures above 240°F to 300°F (115°C to 150°C). If this should happen, remove the entire regulator assembly and dispose of properly. A replacement regulator assembly can be purchased by contacting Brinkmann at

1-800-527-0717. The cause of the excessive heat should be determined and corrected before using your fryer again.

3.A flow limiting device, when activated, restricts the flow of gas to 10 cubic feet per hour.

Manual backgroundWARNING

Never use your fryer without leak testing all gas connections and hoses. See the section on "Leak Testing" in this manual for proper procedures.

Manual backgroundWARNING

The pressure regulator and hose assembly supplied with your gas fryer is designed to work with an LP gas supply cylinder.

DO NOT attempt to connect it to any other fuel supply source such as a natural gas line.

DO NOT use any other pressure regulator/hose assembly other than the one supplied with your fryer.

DO NOT attempt to adjust or repair the regulator. A replacement regulator can be supplied by contacting Brinkmann. The regulator is designed to operate at a maximum output pressure of 10 psi ( pounds/square inch).

During assembly and/or replacement of the gas cylinder, keep the gas supply hose free of kinks and/or damage.

Visually inspect the hose assembly prior to each use for evidence of damage, excess wear, or deterioration. If found, replace the assembly before using your fryer. Only the Brinkmann supplied replacement should be used.

6

Page 7
Image 7
Brinkmann 816-3500 SERIES, 815-3500 owner manual Hose And Regulator